5Press and hold the button on the other remote control, until “OK” appears in the display.
During data transfer, “LEARN” stops flashing.
After data transfer is complete, “OK” appears in the display. Then, the Commander returns to its state in Step 3.
remote control of component
VCR OK
LEARN LEARN
during data transfer
S-3
VCR 
LEARN
data transfer complete
If “NG” flashes twice, and the component name flashes again
Learning was unsuccessful. Try again from Step 4.
6Repeat Steps 4 and 5 to “teach” functions to other buttons.
7Select “EXIT,” then press the Jog dial to finish Learning.
To cancel Learning
Press SET.
Notes
•If you do not perform Learning steps within 30 seconds at any point during the process, the LEARN mode ends.
•If you do not perform Step 5 within 10 seconds after Step 4, the Commander returns to its state in Step 3.
•You cannot teach to the Jog dial and the SET button.
•If the memory of the commander is full, “OVER” flashes, and the Commander returns to its state in Step 3. Erase the already “learned” function (page 21) and start over from the beginning.
If the Commander does not seem to be working
If the “learned” button does not operate properly, “teach” once again. (For example, if the volume becomes very loud after pressing 2 + only once, noise may have interfered during the Learning procedure.)
If you set a component code after “learning” a signal
If you have programmed any signal on a button by the Learning function, that signal will work even after you set a component code.
Note on the REC z signal
You can only “teach” to one button at a time. Therefore you cannot teach a sequential button operation (for example REC z + N) to a single button on your Commander.
Continued
