Changing the Component Selection Order (MOVE) (continued)
The component selection order is changed as follows.
VCR
AMP
TV 
SAT
TAPE 
MD 
CD 
DVD
If you want to move the position again, repeat Steps 3 and 4.
5Select “EXIT,” then press the Jog dial to finish setting.
To cancel setup
Press SET.
Note
If you have set the code number “000” for a component (page 10), it is not displayed.
Tip
You can also skip an unused component by setting its code number to “000” (page 10).
Changing the Name of the Component (NAME)
You can change the name of the component to operate. This is convenient when you are using more than one of the same component.
You can write up to six characters for the component name.
5
Jog dial
1,7
Tip
You can also press b/B instead of turning the Jog dial to the left/right (except for when you select a character to write a name).
You can also press OK instead of pressing the Jog dial.
