Setting the Component Codes (continued)
1Follow Steps 2 to 6 on pages 9 and 10 to go to the PRESET mode.
2Aim the Commander at the component, and press PROGR + or PROGR – and 1 in turn until the component reacts as described in the following.
Powers off: TV
Powers on: VCR, SAT, DVD,
AMP
Plays back: CD, MD, TAPE
Press PROGR + to go to the next code number.
Press PROGR – to go back to the previous code number.
After the numbers have reached the highest limit, they will start over from “000.”
Each time a remote control signal is sent, 
appears in the display.
Tip
It is useful that you take a note of the code number.
3Press the Jog dial.
“OK” appears in the display. The code number is set, and the Commander returns to the Component PRESET mode.
OK
PRESET
TV
PRESET
If you want to set a code for another component, repeat from Step 1 to 3.
4Select “EXIT,” then press the Jog dial to finish setting.
To cancel setup
Press SET.
Note
If you don’t input anything into the Commander for over 30 seconds between each step, the Commander exits SET mode.
Tips
•If you press the Jog dial at “EXIT” on each menu, the Commander returns to the top of the previous mode.
•If you press SET at any point during this operation, the setup procedure will be cancelled. Start over from Step 1.
