Tip

You can freely assign codes to SUB1 through SUB5. Select when you transmit learned codes. For details, see “Setting remote control codes that are not stored in the commander” on page 116.

To perform set up menu operations on the DVD player or satellite tuner

1Select the DVD player from the input list.

2Press the > button repeatedly to display the SUB menu.

To display

Do this

TOP MENU

Press TOP MENU button.

 

 

DVD MENU

Press AV MENU button.

 

 

SET UP

Select “SET UP” in the

 

SUB menu.

3Use the control key to perform menu operations on the DVD player.

Make sure that “DVD” is selected in the CURSOR TYPE list.

To exit the menu operation, press RETURN/ EXIT O. To display the DVD menu, use the AV MENU button (page 17).

Programming the remote

You can customize the remote to match the components connected to your receiver. You can even program the remote to control non- Sony components and also Sony components that the remote is normally unable to control. The procedure below uses as an example a case in which an Aiwa VCR is connected to the VIDEO 2 jacks on the receiver.

Before you begin, note that:

–You cannot change the settings of PHONO.

–The remote can control only components that accept infrared wireless control signals.

Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure.

1

Using

the

2,3,

Remote

4,5

 

1 Press RM SET UP.

The set up list appears.

2 Move the easy scroll key to select “IR SET,” then press the key to enter the selection.

The IR SET list appears.

3 Move the easy scroll key to select the input (i.e, the jack name on the rear panel of the receiver; in this case, “VIDEO 2”), then press the key to enter the selection.

The category list appears.

continued

113GB