About the command mode

If the command modes of the receiver and the remote are different, you cannot use the remote to operate the receiver.

If the command modes of both this receiver and the remote are the initial setting, it is not necessary to reset up them.

Switching the COMMAND MODE

You can switch the command mode (AV SYSTEM 1 or AV SYSTEM 2) of the receiver and the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.

To set up the remote for the receiver

1

2

1 Press RM SET UP.

The set up list appears.

2 Move the easy scroll key to select “COMMAND MODE,” then press the key to enter the selection.

The COMMAND MODE list appears.

3 To select the command mode for the main receiver

Move the easy scroll key to select “MAIN,” then press the key to enter the selection. The MAIN list appears. Move the easy scroll key to select “AV SYSTEM 1” or “AV SYSTEM 2,” then press the key to enter the selection.

Tip

The COMMAND MODE appears in the first line of the display only when the remote is turned on by pressing SOUND FIELD or INPUT SELECTOR.

To set the remote for the receiver on the receiver

Turn on the receiver while pressing 2CH.

“COMMAND MODE [AV2]” appears on the display. Check that the command mode is set to AV SYSTEM2.

If you repeat the same operation again, the setting will change to AV SYSTEM1 from AV SYSTEM2.

When the Sony equipments are operated by remote of the receiver

Change the setting of the receiver and remote to AV SYSTEM1.

46GB