Check that the INPUT MODE is not set to “COAXIAL FIXED” for the sources from the OPTICAL input jack, nor set to “OPTICAL FIXED” for the sources from the COAXIAL input jack.

•Check that the MULTI CH IN function is not selected.

There is no sound when i.LINK is selected.

•Check that the i.LINK component is connected correctly.

•Check that using SCD-XA9000ES is set to output signals from the i.LINK jack.

•The sound may not output when you operate two or more players. In this case, stop the player, which is not selected, then select the player you want to play again by pressing the i.LINK button.

The source sound input from the HDMI jack is not output from an amplifier or the TV speaker connected to the receiver.

•Check the setting of HDMI AUDIO in the CUSTOMIZE menu (page 70).

•Check the HDMI connection.

•The sound is not output when you display the receiver’s menu on the TV monitor. Press ON SCREEN to turn off the display.

•You cannot listen to the Super Audio CD by connecting HDMI.

•Depending on the playback component, component side may need to be set up. Refer to the operating instructions supplied with the each component.

The left and right sounds are unbalanced or reversed.

•Check that the speakers and components are connected correctly and securely.

•Adjust the balance parameters using the LEVEL menu.

There is severe hum or noise.

•Check that the speakers and components are connected securely.

•Check that the connecting cords are away from a transformer or motor, and at least 3

m (10 feet) away from a TV set or fluorescent light.

•Move your TV away from the audio components.

•Make sure you have grounded the U SIGNAL GND terminal (only when a turntable is connected).

•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.

There is no sound from the center speaker.

•Make sure the sound field function is on (press A.F.D., MOVIE, or MUSIC).

•Select the CINEMA STUDIO EX mode (page 92).

•Adjust the speaker level (page 52).

•Make sure the center speaker is set to either “SMALL” or “LARGE” (page 49).

There is no sound, or only a very low- level sound is heard from the surround/ surround back speakers.

•Make sure the sound field function is on (press A.F.D., MOVIE, or MUSIC).

•Select a CINEMA STUDIO EX mode (page 92).

•Adjust the speaker level (page 52).

•Make sure the surround speakers are set to either “SMALL” or “LARGE” (page 49).

There is no sound from the surround back speakers.

•Some discs have no Dolby Digital Surround EX flag even though the packages have Dolby Digital Surround EX logos. In this case, select “ON” (page 95).

There is no sound from the sub woofer.

•When all speakers are set to “LARGE” and “Neo:6 Cinema,” or “Neo:6 Music” is selected, there is no sound from the sub woofer.

The surround effect cannot be obtained.

•Make sure the sound field function is on (press A.F.D., MOVIE, or MUSIC).

132GB