•Sound fields do not function for signals with a sampling frequency of more than 48 kHz.

Dolby Digital or DTS multi channel sound is not reproduced.

•Check that the DVD, etc. you are playing is recorded in Dolby Digital or DTS format.

•When connecting the DVD player, etc., to the digital input jacks of this receiver, check the audio setting (the settings for the audio output) of the connected component.

Recording cannot be carried out.

•Check that the components are connected correctly.

•Select the source component using INPUT SELECTOR.

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

Ground wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 78).

•Press DISPLAY so that the frequency appears on the display.

RDS does not work.*

•Make sure that you’re tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.*

•Contact the radio station and find out whether or not they actually provide the service in question. If so, the service may be temporarily out of order.

 

 

 

There is no picture or an unclear

 

 

picture appears on the TV screen or

Additional

monitor.

 

• Select the appropriate input on the

 

receiver.

 

• Set your TV to the appropriate input mode.

Information

correctly.

• Move your TV away from the audio

 

components.

 

• Assign the component video input

 

• The input signal should be same as input

 

when you are up-converting an input

 

signal with this receiver.

 

The image of the COMPONENT VIDEO OUT is corrupted.

•If PROGRESSIVE OUT is set to “ON,” the image of the signal, which is more than 480i is corrupted when the signals are output from the COMPONENT VIDEO OUT jack. Set PROGRESSIVE OUT to “OFF.”

continued

133GB