5 Point the remote code receiver section of the commander toward the receiver/transmitter on the remote control to be learned from.

About 5 cm - 10 cm (2" - 4")

6 Move the easy scroll key to select “Learning Start,” then press the key to enter the selection.

“Learning Now!!” is displayed.

7 Press the appropriate button on the remote control to send the remote control code.

Lightly pressing the button once should be sufficient. In about 3 to 5 seconds, the display shows whether learning was successful or not. When the learning process completes successfully, “Learning OK!,” the number of keys, and the capacity used for learning are displayed.

When the learning process does not complete successfully, the cause is displayed on the third line.

Move the easy scroll key to return to step 3, then repeat the above procedure.

To cancel learning

Move the easy scroll key to select “Exit” or “Cancel” during any step, then press the key to enter the selection.

Using a command that has been learned

When selecting a learned input, press the button used to learn that function.

To erase the learned code

1In step 6 above, move the easy scroll key to select “Clear,” then press the key to enter the selection. “Clear?” appears.

2Move the easy scroll key to select “Yes,” then press the key to enter the selection. “Cleared!!” appears.

Notes

•The symbols that are displayed in front of the button name indicate the following.

x: already learned

*: pre-programmed

•In step 4, learned buttons can be selected directly. If you press the button you want to use for the Learning function, the list will jump to the same button.

•The Learning function can be applied to the SUB menus. SUB1–SUB5 can be learned.

•You can set input names for SUB1–SUB5.

1In step 6, move the easy scroll key to select “NAME,” then press the key to enter the selection.

2Move the easy scroll key to create a name, then press the key to enter the selection (up to 8 characters).

+/–: Select a character

</>: Move the cursor

Insert: Insert a space

Delete: Delete a character

•You can program up to 80 buttons for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons.

•If you select “IR SET” for a component that already has a learned button setting, the learned codes for that component are cleared. However, if the cleared learned button is used in a Macro Play setting, the setting for that button will be reset to the initial setting.

Remote the Using

117GB