Notes on converting video signals

•You can convert only the 480i of component video signals into HDMI signals, S-VIDEO signals, or VIDEO signals. Signals are converted from 480i interlace scanning to 480p progressive scanning, then the signals are output.

•When video or S-video signals from a VCR, etc., are converted on this receiver and then output to your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image may be output.

•An HDMI video signal cannot be converted to a component signal, an S-video signals and video signal.

•REC OUT does not have an up convertion function.

•S2 information (aspect information for the images) included in S-video signals is effective only when S-video input signals are output from the S-video MONITOR OUT jack. An aspect ratio of images may not be displayed correctly when video signals and component video signals are converted and are output from the S-video MONITOR OUT jack.

•(Models of area code CEL only)

SECAM video signals are converted to PAL signals and output when VIDEO CONVERT is “ON.” Set VIDEO CONVERT to “OFF,” when you output signals in SECAM system.

Closed Caption display

•Set VIDEO CONVERT to “OFF” when receiving a signal that supports Closed Captions. If VIDEO CONVERT is set to “ON,” you cannot display Closed Captions.

•Only component video input signals of 480i are accepted when “PROGRESSIVE OUT” is set to “ON.”

Assigning video input signals to other input

Component video input signals and HDMI input signals can be assigned to other input (page 63, 64, 70).

34GB