![](/images/new-backgrounds/1260927/26092775x1.webp)
O P E R A T I O N | For Machines Mfg. Since 3/11 |
7.Verify that the chuck fits the spindle properly by checking for any gaps between the mating surfaces.
—If there are no gaps, proceed to Step 8.
—If there is a gap, remove the chuck, re- clean the mating surfaces carefully, and
8.Verify that the chuck/spindle tapers are seated firmly together by removing the chuck, per the Chuck Removal instructions, and pay close attention to how easily the tapers release.
—If it was necessary to bump the chuck or use a mallet to release the tapers, then they are seating together properly.
—If the tapers released easily with little intervention, they are not seated together firmly as required. Remove the chuck, re- clean the mating surfaces carefully, and
Registration Marks
Lightly stamp registration marks across the mating seams of chuck components. These marks will help you
Camlock | Spindle & Chuck | |
Registration Marks | ||
Spindle | Chuck | |
| ||
| Halves | |
Marks | ||
for Chuck | ||
Direct Mount | ||
Reassembly | ||
Camlock Chuck | ||
|
Figure 40. Registration mark locations.
Chuck Removal
To remove the chuck:
1.DISCONNECT LATHE FROM POWER!
2.Use an appropriate lifting, support, or protective device to protect the ways and support the chuck.
3.Loosen the camlocks by turning the key counterclockwise until the cam lines are aligned with the mark on the spindle nose.
Tip: Camlocks can become very tight. A cheater pipe may be used as a last resort to add leverage when loosening. After loosening, you may need to wiggle the chuck key in the camlock to fully disengage the stud.
Cam line aligned with spindle mark |
Figure 41. Camlock is fully loosened when the cam
line is aligned with the spindle mark.
4.Using a dead blow hammer or other soft mallet, lightly tap around the outer circumference of the chuck body to loosen it from the spindle.
5.Remove the chuck from the spindle, using a light rocking motion to carefully slide the studs out of the bores.
—If the chuck does not immediately come off, rotate it approximately 60˚ and tap it again. Make sure all the marks on the cams and spindle are in proper alignment for removal.