For Machines Mfg. Since 3/11

P R E P A R A T I O N

16-Speed Gearhead Lathe

Preparation Overview

The purpose of the preparation section is to help you prepare your machine for operation. The list below outlines this basic process. Specific steps for each of these points will be covered in detail later in this section.

The typical preparation process is as follows:

1.Unpack the lathe and inventory the contents of the box/crate.

2.Clean the lathe and its components.

3.Identify an acceptable location for the lathe and move it to that location.

4.Level the lathe and either bolt it to the floor or place it on mounts.

5.Assemble the loose components and make any necessary adjustments or inspections to ensure the lathe is ready for operation.

6.Check/lubricate the lathe.

7.Connect the lathe to the power source.

8.Test run the lathe to make sure it functions properly.

9.Perform the spindle break-in procedure to prepare the lathe for operation.

Things You'll Need

To complete the preparation process, you will need the following items:

For Lifting and Moving

ss!!FORKLIFT ORLOTHERTPOWERRLIFTINGHDEVICE RATED for at least 5000 lbs.

ss,IFTINGTstraps rated for at least 5000 lbs. each

ss/PTIONAL #HAIN WSAFETYHHOOK RATED FOR ATF least 5000 lbs. each

ssTwo other people for moving machine ss Two 12" 2x6's

ss 0RECISIONILEVEL

For Power Connection

ssA power source that meets the minimum circuit requirements for this machine (review the Power Supply section on Page 19 for

details)

ssAn electrician or qualified service personnel to ensure a safe and code-compliant connection to the power source

For Assembly

ssCotton rags

ssMineral spirits

ssQuality metal protectant oil ss 3AFETY glasses

ss Wrench or socket 21mm ss Wrench or socket 19mm

ss &LOOROmounting hardware as needed ss Standard screwdriver #2

-17-

Page 19
Image 19
Southbend SB1053 owner manual Preparation Overview, Things Youll Need, Typical preparation process is as follows