For Machines Mfg. Since 3/11

O P E R A T I O N

16-Speed Gearhead Lathe

14 or 34 Fractional TPI

For TPI that have a 14 or 34 fraction, use position 1 on the thread dial (see Figure 94).

TPI

2¼,2¾,

Position

3¼,3¾

1 Only

 

 

Figure 94. Position for 14 or 34 fractional TPI.

278 TPI

The thread dial is not used for 278 threading or metric threading (see Figure 95). The half nut must stay engaged with the leadscrew throughout the entire threading operations.

278

Same as

Thread Dial

 

Metric

 

Not Used

 

 

Threads

Chip Drawer

The chip drawer shown in Figure 96 catches swarf and metal chips during the machining process. It easily slides open to provide access to swarf during cleanup.

Also, the chip drawer contains a screen that allows run-off coolant to drain back into the reservoir.

Chip

Drawer

Figure 96. Chip drawer.

Figure 95. Half nut stays engaged for 278 TPI.

If pulled out quickly and more than halfway, the drawer could fall out and hit your legs and feet, causing serious injury. Therefore, open the drawer slowly and avoid opening it more than halfway.

-61-

Page 63
Image 63
Southbend SB1053 owner manual Chip Drawer, ⁄4 or 3⁄4 Fractional TPI, 27⁄8 TPI