16-Speed Gearhead Lathe

O P E R A T I O N

For Machines Mfg. Since 3/11

Power Feed Controls

Use Figures 77–80and the following descriptions to become familiar with the locations and functions of the controls that you will use to set up the correct power feed for your operation.

Note: Before using power feed, you may have to re-configure the end gears, depending on how they are set up. Refer to End Gears on Page 56 for detailed instructions.

Feed Range Lever: Selects the low or high feed rate range by re-aligning the headstock transfer gear. In the middle position, disables power feed (see Figure 77).

LOW

Neutral

HIGH

Figure 77. Feed range lever.

Feed Direction Lever: Selects the direction of power feed (see Figure 78).

Note: The spindle must be stopped to use this lever. When the lathe is running, use the quick- change feed direction knob on the apron.

FORWARD

REVERSE

Figure 78. Feed direction lever in the neutral position.

Quick-Change Gearbox Feed Levers: Configure the quick-change gearbox gears for the feed rate selected (see Figure 79).

Left

Middle Right

Bottom

Figure 79. Quick-change gearbox levers.

Feed Control Lever: Directs the power feed to either the cross slide or the carriage (see Figure 80).

When the lever is down and the indent pin is pointing up, the cross slide is selected. Conversely, when the lever is up and the pin is pointing down, the carriage is selected.

In the middle position, the apron gears are disengaged from the feed rod and neither component will move.

Note: When using this lever, you may need to slightly rotate the handwheel of the component you are trying to engage, so that the apron gears can mesh.

Cross Slide

Neutral

Carriage

FEED CONTROL

LEVER

Feed Direction

Knob

Feed Control Lever

Figure 80. Apron power feed controls.

-54-

Page 56
Image 56
Southbend SB1053 owner manual Power Feed Controls, Feed direction lever in the neutral position