NOTE
To change from Cursor Mode to Home Mode press [CLEAR].
Home mode
When the 
ships icon is only shown on the Chart page (cursor is not shown) you are in home mode. Now as the ship moves through the water the vessels position will be kept in the center of the display.
3.1.2Cursor and Menu selection speed
The chartplotter allows you to control the speed the Cursor moves when the ShuttlePoint knob is pressed. To change the speed:
Figure 3.1.2 - Cursor Speed menu
1.Press [MENU]. Move the ShuttlePoint knob to SETUP and either press [ENTER] or move the ShuttlePoint knob to the right.
2.Move the ShuttlePoint knob to CURSOR SPEED and press [ENTER] or move the ShuttlePoint key to the right.
3.The menu now shows two selections, CHART and MENU which allows the cursor speed to be selected to High, Medium or low on Chart page or within the menus.
4.With CHART or MENU selected press [ENTER] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to the desired setting and press [ENTER] or move the ShuttlePoint knob to the right.
5.Press [CLEAR] until the menu disappears or an easier method is to press the Shuttlepoint knob to the left a few times.
6.Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3Changing the Ships Icon
The cursor may be changed to any of the following:
Figure 3.1.3 - Ships icons
Page 28 |
| GPS chartplotters |
|
