Standard Horizon CP155C, CP1000C, CP175C owner manual Nmea Display, Changing the Nmea page Windows

Models: CP175C CP155C CP1000C

1 82
Download 82 pages 28.09 Kb
Page 61
Image 61

10.6NMEA DISPLAY PAGE

The chartplotter is capable of displaying information in the customizable data windows from external NMEA devices. Depth sounder, Speed Log with temp, Wind speed and direction, Flux gate compass, and GPS information can be shown in any of the boxes. The default NMEA Display shows 3 windows. When going to a destination, this screen is useful to navigate as to get to the destination keep the Course Over Ground (COG) and Bearing (BRG) figures the same.

Figure 10.6 - NMEA Display page

The NMEA sentences read from external devicecs are: BWC, DSC, DSE, GGA, GLL, GSA, GSV, HDG, HDM, HDT, RMC, VHW, VTG, DPT, DBT, MTW, VWR, VWT, TLL, WPL, RTE.

CHANGING the NMEA PAGE Windows

1a. On the CP155C, press [MENU] and highlight NMEA DISPLAY with the ShuttlePoint knob and press [ENTER].

2.The CP175C and CP1000C can use step 1a, and a from the factory the right most Soft Key is programmed for direct access. Press this key two times to show the NMEA

Display page.

2a. Move the ShuttlePoint knob to DISPLAY and press [ENTER].

3. To change the 5 different pages move the ShuttlePoint knob to the left or right.

10.7NMEA DATA PAGE

The NMEA Data Page is very useful to see if a External device (example: Depth Sounder) is transmitting NMEA sentences to the GPS chartplotter. This page can also be used to see if the GPS chartplotter NMEA output is being loaded down by a external NMEA device the GPS chartplotter is connected to.

Scenario: VHF Radio connected but the radio is not receiving a GPS Position.

Usually the VHF radio will be connected to the Green and Brown wires. To check to see if the GPS chartplotter is transmitting the sentences:

1.Press [MENU] and highlight NMEA DISPLAY with the ShuttlePoint knob.

2.Press [ENTER] or move the ShuttlePoint knob to the right.

3.Move the shuttlepoint to highlight DATA.

4.Press [ENTER] or move the ShuttlePoint knob to the right.

5.Connect the BLUE Wire on the GPS chartplotter to the junction of the Brown wire and the VHF wire. The display should look similar to the picture below.

GPS chartplotters

 

Page 63

 

Page 61
Image 61
Standard Horizon CP155C, CP1000C, CP175C owner manual Nmea Display, Changing the Nmea page Windows