Standard Horizon CP175C Selecting Loran TD or Other Coordinate System, Coordinate System Menu

Models: CP175C CP155C CP1000C

1 82
Download 82 pages 28.09 Kb
Page 29
Image 29

1.Press [MENU] , select SETUP and press [ENTER] or move the shuttlepoint knob to the right.

2.Move the ShuttlePoint knob to GENERAL SETUP and press [ENTER] or move the ShuttlePoint knob to the right.

3.Move the shuttlepoint knob to TIME SETUP and press [ENTER] or move the shuttlepoint knob to the right.

4.Move the shuttlepoint knob to GPS TIME OFFSET and press [ENTER] or move the shuttlepoint knob to the right.

5.Move the ShuttlePoint knob down to select +00:00 , press [ENTER] and move the ShuttlePoint knob to the right to edit the number.

6.Look at the table and find the offset for your area. You will need to enter this offset to make the GPS chartplotter show the correct time.

7.Move the Shuttlepoint knob the “+”. Move the ShuttlePoint knob up or down to change to the desired offset.

8.Next move the ShuttlePoint to the right to select Hours and move the ShuttlePoint up or down to change the hour.

9.Repeat this method to change the minutes if necessary.

10.Once you have the correct GPS time offset, press [ENTER] to set.

3.3SELECTING LORAN TD OR OTHER COORDINATE SYSTEM

The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TD’s or UTM. Below is the window that will appear when customizing the coordinate system.

Figure 3.3 - Coordinate System Menu

1.Press [MENU] and move the ShuttlePoint knob to select SETUP.

2.Move the ShuttlePoint knob to ADVANCED SETUP and press [ENTER] or move the ShuttlePoint knob to the right.

3.Move the shuttlepoint knob the select NAVIGATE.

4.Press [ENTER] or move the ShuttlePoint knob to the right and select COORDINATE SYSTEM.

5.Press [ENTER] or move the ShuttlePoint knob to the right to show the coordinate selection popup window.

6.Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENTER] or move the ShuttlePoint knob to the right.

7.Press [CLEAR] or move the ShuttlePoint knob to the left until the chart page is shown.

NOTE

If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are

GPS chartplotters

 

Page 31

 

Page 29
Image 29
Standard Horizon CP175C, CP1000C, CP155C owner manual Selecting Loran TD or Other Coordinate System, Coordinate System Menu