Star Micronics NX-2415II user manual I+“ //” \EsY Ll

The parallel cable which you can use has a 25-pin D-type plug at one end, and a 36-pin Centronics connector at the other.

Follow the procedure below to connect the interface cable:

1.Turn off the power switch on both the printer and the computer.

2.Plug the cable’s Centronics connector into the socket on the side of the printer as shown in Figure 2-9.

Make sure that you press the plug into the interface connector.

I+“ //” \EsY Ll

Figure 2-9. Connect the interface cable.

3.Move both clips inside the extended prongs on the sides of the plug until you hear a click.

Figure 2-70.Move the clips until you hear a click.

4.Plug the 25-way plug into the parallel socket onyourcomputer. This will

probably be Iabelled “Printer”, “Paral]el”, “PRN”, “LpTl” or something similar.

14