Star Micronics NX-2415II user manual Loading the paper

Loading the paper

If you are going to load the paper with the optional Pull tractor unit, refer to Chapter 7.

1.Place a stack of fanfold paper behind and at least one page-length below the printer.

2.Turn the printer’s power OFF.

3.Push the release lever forward. This has the effect of releasing the paper from the platen roller, and engaging the tractor feed.

4.Remove the rear cover. Grip it by its rear edge and lift upwards and backwards as in Figure 3-7.

I

Figure 3-7. Remove the rear cover.

5.With the tractor covers open, mount the paperby aligning holes with the pins on the tractor unit.

6.Adjust the spacing of the tractor units by sliding them along the bar, using the clamp lever at the back of each unit to release them and lock them in position. The unit is released when the clamp lever is down and locked when the clamp lever is up.

23