Star Micronics NX-2415II user manual Tractor cober, CIamp lever

Tractor cober CIamp lever

Figure 3-8.Mount the fanfold paper over the tractor units.

7.Now close the tractor covers, again making sure that the paper holes are aligned with the pins on the tractor units. If they are not aligned properly, you will have problems with paper feeding, possibly resulting in tearing and jamming of the paper.

8.Remount the rear cover. Hold it tilted upward and insert the four tabs at the front into their slots. Then rotate the cover downwards, pressing down on the thumb pads on the left and right to snap it into place.

9.Mount the paper guide in the horizontal position, as shown in Figure 3- 9. This will separate the printed from the unprinted paper.

10.Turn ON the power at the switch located at the front of the printer. The printer will beep, indicating that the paper is not yet fully loaded. The POWER indicator will also flash to confirm this.

11.Now press the (SET/EJECO button. The paper will be fed and adjusted past the print head to a position ready for printing.

12.If you want to set the paper to a different position, set the printer off-line by pressing the (ON LINE) button, then set the paper by using the micro- feed function. (For details, refer to Chapter 4.)

24