Star Micronics NX-2415II user manual Setting up

Setting up

The procedure for installing the ASF is:

1.Usethe printer’s EDS mode to specify ASF as “installed”. (For details, refer to Chapter 5.)

2.Open the front cover by lifting up the front using the two grips on either side, then remove the cover by pulling up.

3.Remove the paper guide, and move the release lever at the back of the printer to the rear position as shown in Figure 7-2.

4.Move the bail lever on top of the printer to open the paper bail.

Figure 7-2.Remove the front cover from the printer.

5. Secure the mounting brackets of..the Automatic Sheet Feeder onto the

shaft of the platen by lowering it into position as shown in Figure 7-3.

I

Figure 7-3.Mount the Automatic Sheet Feeder onto the printer

54