Star Micronics NX-2415II user manual Switch B-2 Paper-out, Switch B~5 CR Centering

Switch B-2: Paper-out

When this switch is OFF the printer ignores the paper-out detector and prints down to (and beyond) the bottom edge.

Switch B-3:Printable area

This printer can use two types of printing area format.

By putting the switch ON (Type A), the first line of printing will start 1/6inch from the top of the paper, and the printed area will end 1/6inch from the bottom of the paper.

By putting the switch OFF (Type B), the first line of printing will start one inch from the top of the paper, and the printed area will end 6 mm from the bottom of the paper,

Switch B-4:This switch is used for technical purposes only. Leave this switch ON.

Switch B~5: CR Centering

If you set this switch OFF, the carriage moves to the center each time to feed paper nears the perforations. This way, you can get better quality of printing around the perforations. It is recommended to match the page length setting to your fanfold paper; otherwise, this function does not work properly at the perforations.

If you leave this switch ON, the carriage does not move when feeding paper.

Switches C-1 to C-3: Page Length

Leave these switches ON if you will be using 1l-inch forms. You will need to change the switches as shown below if you will be using a different page length:

Page Length	c-1	c-2	c-3
11 inches/Letter	ON	ON	ON
8 inches	OFF	ON	ON .
11.7 inches/A4	ON	OFF	ON
12 inches	OFF	OFF	ON
8.5 inches	ON	ON	OFF
14 inches/Legal	OFF	ON	OFF
10.5 inches/Executive	ON	OFF	OFF
7.25 inches	OFF	OFF	OFF

44