Star Micronics XB24-10 Select character table, Both, Select primary character set, Standard

Select character table

<ESC>	t	Cn>	Both
1Bh	74h	Cn>
27	116	<n>
<FS>	I	<n>	Standard
1Ch	49h	<n>
28	73	Cn>

The command above will select the character table to be used in subsequent printing, where vt> can be a binary or ASCII value from OOhthrough 02h or “0” through “2”. The following table shows the effect of this parameter:

Cl

Moves character set downloaded in OOhto 7Fh area to

Any other values are invalid and will be ignored.

Select primary character set		Both
<ESC>	7
1 1Bh	37h
27	55

The command above selects the primary character set.

There are no parameters. The area 6om 8Ohto 9Fh is used for control codes.

Select secondary character set Both

<ESC>6

1 27

The command above selects the secondary character set.

There are no parameters. The area from 8Ohto 9Fh is used for printable characters.

28