Star Micronics XB24-15 I Set MS6 to, Standard, 1Cancel MSB control, Both, Select zero style

I Set MS6 to 0
<ESC>	=	Standard
1Bh	3Dh
27	61
<FS>	=	IBM
	3Dh
1 28	61

The command above sets the MSB to 0. There are no parameters. On receipt of this command, the most significant bit (MSB) of subsequent data will always be set to 0.

1Cancel MSB control		Both 1
rcESC>		I
1Bh	23h
27	35

The command above cancels software control of the MSB. There are no parameters. On receipt of this command, software control of the most significant bit (MSB) by the cESC>>, <ESC>= (standard) or <FS>= (IBM) commands, will be cancelled.

Select zero style Both

<ESC>

1Bh7Eh

* 27126

The command above selects the style in which zeroes will subsequently be printed, where cn> is either a binary value of OOhor Olh or an ASCII value of “0” or “1”. If 01> is OOhor “O”,then “normal” (non-slashed) zeroes will be printed, but if it is 01h or “l”, then the “computer-style” (slashed) zero style wiIl be printed (this overrides the Memory Switch setting, in Chapter 3).

61