Star Micronics XB24-10, XB24-15 Reset, ASF Automatic Sheet Feeder control, Both, Standard

Reset

<ESC>	@	Both
1Bh	40h
27	64

cFs>	@	Standard
1Ch	40h
28	64

The command above resets the printer. There are no parameters. On receipt of this command, the buffer is cleared, and all settings (with the following exceptions) are restored to their power-up values.

•ASF settings made with the cESC> EM command

•Panel mode settings

ASF (Automatic Sheet Feeder) control			Both
&SC>	CEW	C?P
1Bh	19h	<n>
27	25	C?D

The command above controls the operation of the ASF, where <EM> is the ASCII code 19h, and QD may take the binary values OOhor 04h or the ASCII values “R” or “T’. The effect of these values is summarized below:

Value	Effect
OOh	1 Selectmanualmode
04h	Select auto mode
“R”	Eject paper
‘T”	Set top print position. This parameter must be
	followed by anot+ binary value (>l) signify-
	ing the ditance (m l/6 inch units) at which
	printing should start below the top of the paper.

These commands will be ignored if the ASF has not been selected.

66