Star Micronics XB24-10, XB24-15 user manual Enable/disable double-height mode, Both, Standard

Enable/disable double-height mode

&SC>	W	Cn>	Both
1 1Bh	77h	CID
27	119	Cn>
<FS>	V	Cn>	Standard
1Ch	56h	Cn>
28	86	C?D

The command above enables or disables double-height printing, where <n> is a binary value of either OOhor 01h or an ASCII value of either “0” or “1”. If oI> is set to OOhor %“, then double-height printing is cancelled. If cn> is set to Olh or “1”. then double-height printing is enabled. The character width is unaffected. It is the user’s responsibility to alter the line pitch so that it is in accordance with the new character height, and to produce a line feed at the new pitch in order to leave sufficient space for the new characters. If there are different sizes of print on the same line, the printing will be aligned along the bottom of the normal-sized characters. Any previous commands for vertical enlargement of characters will be cancelled by this command.

Select character height, width, line spacing					Both
-diSC>	1	@		all>	<Nub
	uib	UJ3>
1Bh	5Bh	40h	ao>	OrI>	OOh
OOh	Cd>	Cd>
27	91	64		cd>	0
0 <	Cd>	Cd>

The command above is used to control character height, width and line spacing, where cno> and cnl> (low byte first) ate used to supply the number of subsequent data bytes (1 or 2). The effect of the hvo data bytes (<n2> and cn3>) is determined as follows:

66