Star Micronics XB24-10 Horizontal print position control codes, 1Set left margin, Both, Standard

1Set left margin			Both 1
1 cESC>	1	<tP	I

1Bh6ChCn>

27108 <II>

The command above sets the left margin, where “1”is a lowercase “‘L”(not “one”), and en> is a binary value used to set the left margin. The margin is defined in terms of the number of character positions at current pitch. If proportional spacing has been selected, then the character width for pica pitch is used. The left margin may not be closer than two print positions to the right margin, otherwise this command is ignored.

Set right margin
<ESC>	Q	Cn>	Standard
1Bh	51h	Cn>
1 <FS>	Q	<n>	IBM 1
1Ch	51h	<n>
28	81	<ID

‘Ihe command above sets the right margin, where 01> is a binary value used to set the right margin in character spaces at the current pitch. If proportional spacing has been selected, then the character width for pica pitch is used.

Horizontal print position control codes

Move print position to the right			IBM	--
<ESC>	d	elo,	alI>
1Bh	#h	ore>.	cd>
27	100	c?lo>	Cd>

The command above moves the current print position to the right, where cno> and ad> (low byte first) indicate the amount by which the print position will be moved in l/120 inch units. If this command would set a print position beyond the right margin, then the print position moves only to the right margin. If underlining or overlining is in effect prior to the receipt of this command, then the slopped space will also be underlined or overlined (cf horizontal tabs).

48