Star Micronics XB24-15, XB24-10 Select International character set, print continuously, Standard

Select International character set

<ES6 R <n> Standard

iBh52h

2782

<FS>R

1Ch52h

The command above selects an international character set, where <n> is a binary value in the range OOhthrough ODh. The character set selected is dependent on the value of 01>, as shown in the table below:

Any other values of OI> are invalid and will be ignored. The special characters affecting each symbol set are given in Chapter 9.

print continuously		from the All Characters Chart		IBM
<ESC>	\	ulo>	cd>
1Bh	5Ch		cd>
1 27	92	ulo>	cd>	I

The command above allows a series of special characters to be printed from the control code area (OOhthru 1Fl-r).where the two parameters give the total number of characters to be printed (low byte rust). On receipt of this command, any codes received in the range OOhthrough 1Fh will not be interpreted as control codes, but will print the characters corresponding to those codes. This will continue for the number of characters designated by u10> and -al>.

29