Star Micronics XB24-10, XB24-15 user manual Either send a FF or enough LF commands to eject

If the paper park facility does not appear to be working correctly, check the following:

1 Check I Possible remedy I

Is the paper release lever in the m position?

Has the fanfold paper been properly parked?

The paper release lever must be set to the & position after the fanfold paper has been parked.

Make sure that the PAPER indicator comes on after the fanfold naner has been uarked.

If the short tear-off function does not appear to be working properly, check:

Check	Possible remedy
Has printing ended in the	Either send a <FF> or enough <LF> commands to eject
middle of a page?	the page.

If text is being printed all on one line, or with extra blank lines, check the following:

1 Check 1 Possible remedy I

Is the text all on the same Carriage returns are not being expanded to

line?<CR> +<LF> pairs. Check the Memory Switch setting and correct.

Is text being printed with extra blank lines?

Two line feeds are being printed. Either make your software print just a carriage return or (if this is not possible), set the AUTO LF to OFF using the Memory Switch menus.

If the page length and margins are not what is expected, check the following:

Check

Is the piriming starting too high or too low on the page?

Does the printer’s page lengthnotmatchthephysical page length?

Is the Skipover perforation facility not working?

Possible remedy

Use the Micro Feed facility to adjust the print position relative to the page.

Use the Memory Switch settings, or the DIP switch to set up the correct page length, or use software com- mands to do it.

Make sure this is set with the Memory Switch menus. If the skip occurs in the wrong place, make sure the page length is properly set, and that the top of the print position is about two lines down from the top of the

Paper-

60