State Industries SUF-60-120 Lighting The Water Heater, SUF 60 120 AND SUF 100 150 MODELS ONLY

Lighting The Water Heater

Lighting & Operation Labels

The instruction label below is affixed to the water heater's covered by this manual at the factory and must be followed when lighting and operating the water heater.

SUF 60 120 AND SUF 100 150 MODELS ONLY

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

“WHAT TO DO IF YOU SMELL GAS”

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any telephone in your building.

•Immediately call your gas supplier from a neighbor’s

telephone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above on this label.

2.Set thermostat to lowest setting.

3.Turn off all electrical power to the appliance.

4.This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

5.Move “Off/On” switch to the “Off” position.

Wait five (5) minutes to clear out any gas. If you then

smell gas,	STOP! Follow “B” in the safety information
above on	this label. If you don’t smell gas, go on to
the next step.

7.Turn on all electrical power to the appliance.

8.Set thermostat to desired setting.

9.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

O W	F
	L

On/Off Switch	REG ADJUST
ON	OFF

6.Move “Off/On” switch to the “On” position.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electrical power to the appliance if service is to be performed.

3.MOve “Off/On” switch to the “Off” position. Do not force.

56