Sterling 882.00249.00 manual SET Pump Stage TIME? NO/YES, Stage Delay 3.000s

Setting the Pump Stage Time

Pump stage time is a delay that prevents both pumps from engaging at the same time. Although rare in a two-pump system, both pumps can sometimes start at the same time. This condition causes an excess of current on the electrical system from such a surge.

The pump stage time delay defaults to 3.0 seconds and should not be altered unless you are instructed to do so by the Service Dept.

SET PUMP STAGE TIME?

NO/YES

At the above message prompt:

1. Press the YES key to enter the Pump Stage Time menu.

STAGE DELAY: 3.000s

PRESS ENTER TO SAVE

Using the keypad:

2. Enter the new time and press the ENTER key to save the new setting.

2–Pump 12-Station Controllers Chapter 8: Service Only Information 59