7 SCAN OPERATION

Scan resume condition

[

The scan resume condition can be selected as timer or pause scan. The selected resume condition is also used for priority watch. (p. 47)

The display shows that the scan will resume 15 sec. after it stops.

qPush [SET•LOCK] to enter set mode.

wPush [SET•LOCK] or [S.MW•MW] several times until “SCT” or “SCP” appears as shown above.

When “d” is displayed in place of the 100 MHz digit, cancel the DTMF memory encoder in advance. (p. 50)

eRotate [DIAL] to set the desired timer:

“SCT-15” : Scan pauses 15 sec. while receiving a signal.

“SCT-10” : Scan pauses 10 sec. while receiving a signal.

“SCT-5” : Scan pauses 5 sec. while receiving a signal.

“SCP-2” : Scan pauses until the signal disappears and then resumes 2 sec. later.

rPush [MONI•DTMF] to exit set mode.

SET

B

zPush [BAND] to select the desired band. x Push [SET B(D-OFF)] to enter set mode.

cPush [SET B(D-OFF)] or [ENT C(T-OFF)] several

times until “SCT” or “SCP” appears as shown at left.

vPush [Y] or [Z] to select the scan resume condi- tion.

See item r at left for scan resume condition details. b Push [CLR A(MW)] to exit set mode.

45

Page 60
Image 60
Icom IC-208H instruction manual Scan resume condition, Rotate Dial to set the desired timer