Icom IC-208H instruction manual Memory Operation, General description, Memory channel selection

■General description

The transceiver has 512 memory channels including 10 scan edge memory channels (5 pairs), and 2 call channels. Each of these channels can be individually programmed with operat- ing frequency (pgs. 11, 12), duplex direction (p. 21) and off- set (p. 24), subaudible tone encoder or tone squelch and its tone frequency (pgs. 20, 22, 52, 53) and skip information* (p. 44).

In addition, a total of 10 memory banks, A to J, are available for usage by group, etc.

*except for scan edge memory channels.

■Memory channel selection

DUsing the tuning dial

qPush [M/CALL•PRIO] several times to select memory mode.

• “!” indicator appears

[M/CALL•PRIO] “!” appears

wRotate [DIAL] to select the desired memory channel.

• Programmed memory channels only can be selected.

MEMORY OPERATION 5

DUsing the [Y]/[Z] keys

	z Push [MR/CALL] to select memory mode.
MR/CALL x Push [Y] or [Z] to select and set the desired		4
	memory channel.
Y/Z	• Pushing [Y]/[Z] for 1 sec. activates a scan.	5
	• If scan is activated, push [Y]/[Z] again or push

[CLR A(MW)] to stop it.

DUsing the keypad

zPush [MR/CALL] to select memory mode. MR/CALL x Push [ENT C(T-OFF)] to activate the keypad

for numeral input.

c Push 3 appropriate digit keys to input a chan- nel number.

•Blank channel can be selected.

•Push only 1 appropriate digit key, [MONI 1(BANK)],

[SCAN 2(T-SCAN)],[PRIO 3(PTT-M)],

[HIGH 4(DTCS)] or [MID 5(DTCSS)] then push [M(TONE-1)] or [SQLZ #(16KEY-L)] to select scan edge channels. “M” and “#” can be used for “A” and “b” respectively.

26