Icom IC-208H instruction manual Transmitting a Dtmf code, Automatic transmission Dtmf memory

■Transmitting a DTMF code

DAutomatic transmission (DTMF memory)

qPush [MONI•DTMF] for 1 sec. to turn the DTMF memory encoder ON.

• “d” appears in place of 100 MHz digit.

wPush [SET•LOCK] to enter DTMF memory programming

condition.

eRotate [DIAL] to select the desired DTMF memory chan- nel.

rPush [PTT] to transmit the selected DTMF memory content. tPush [MONI•DTMF] for 1 sec. to cancel the DTMF en-

coder.

•When the DTMF encoder is turned ON continuously, each push of the PTT transmits the previously selected DTMF code.

zPush [FUNC] then [LOW 6(DTMF)] to turn the

DTMF DTMF memory encoder ON.

•“d” appears in place of 100 MHz digit.

x Push [SET B(D-OFF)] to enter the DTMF memory programming condition.

cPush [Y] or [Z] to select the desired channel. v Push [PTT] to transmit the selected memory.

•Exit the programming condition automatically.

•Each push of [PTT] transmits the DTMF code.

bPush [FUNC] then [SET B(D-OFF)] to cancel the DTMF memory encoder.

•When the DTMF encoder is turned ON continuously, each push of the PTT transmits the previously se- lected DTMF code.

DTMF MEMORY ENCODER 9

DTransmitting a DTMF memory directly

zPush [FUNC] then [LOW 6(DTMF)] to turn the

DTMF-SDTMF memory encoder ON.

•“d” appears in place of 100 MHz digit.

x Push [DTMF-S] to turn the DTMF memory di- rect selection ON.

•The function indicator (microphone) lights green. c Push the desired DTMF channel.

•“0” to “9” and “A” to “D” are available for DTMF memory channels.

•The selected DTMF code is automatically transmit-

ted without pushing PTT. 9

NOTE: When no DTMF code programmed

channel number is pushed, it transmits the rela-

tive DTMF code as the manual transmission de- scribed in the next page.

vPush [DTMF-S] again to deactivate the DTMF memory direct selection.

bPush [FUNC] then [SET B(D-OFF)] to cancel the DTMF memory encoder.

50