Offset frequency [

When communicating through a repeater, the transmit fre- quency is shifted from the receive frequency by an amount determined by the offset frequency.

Independent offset frequencies can be set for each operating frequency.

qPush [BAND] to select the desired frequency band.

wSelect the desired mode/channel you wish to set the offset frequency, such as VFO mode or memory/call channel.

The offset frequency can be independently programmed into each mode or channel.

ePush [SET•LOCK] to enter set mode.

rPush [SET•LOCK] or [S.MW•MW] until “DUP” and offset frequency appear.

[SET•LOCK]

“DUP” and offset frequency appear

tRotate [DIAL] to set the desired offset frequency. yPush [V/MHz•SCAN] to exit set mode.

REPEATER OPERATION 4

zPush [BAND] to select the desired frequency

SET band.

B• Enter the desired frequency via the keypad if neces-

sary.

4

xSelect the desired mode/channel you wish to set the offset frequency, such as VFO mode or memory/call channel.

The offset frequency can be independently pro- grammed into each mode or channel.

cPush [SET B(D-OFF)] to enter set mode.

vPush [SET B(D-OFF)] or [ENT C(T-OFF)] until “DUP” and offset frequency appear.

Push

bPush [Y] or [Z] to set the desired offset.

Direct frequency entry from the keypad is not possi- ble.

nPush [CLR A(MW)] to exit set mode.

NOTE: The offset frequency can be set in a memory/call channel temporarily. However, the set frequency is cleared once another memory channel or VFO mode is selected. To store the offset frequency permanently, overwrite the channel information.

24

Page 39
Image 39
Icom IC-208H Offset frequency, Push Band to select the desired frequency SET band, Push Y or Z to set the desired offset