Icom IC-208H Scan edges programming, Example Programming 145.300 MHz into scan edges 1A

■Scan edges programming

Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 1A/1B to 5A/5B, in memory channels.

SCAN OPERATION 7

rPush [S.MW•MW] for 1 sec. to program.

•3 beeps sound and VFO is automatically selected.

•Scan edge 1B, 2B, 3B, 4B or 5B is automatically selected when continuing to push [S.MW•MW] after programming.

qSet the edge frequency of the desired frequency range in VFO mode:

➥Set the frequency using [DIAL].

➥Set other data (e.g. repeater settings, etc.) if desired. w Push [S.MW•MW].

• “!” indicator and channel number blink.

e Rotate [DIAL] to select one of scan edge channel, 1A, 2A, 3A, 4A or 5A.

tTo program a frequency for the other pair of scan edges, 1B, 2B, 3B, 4B or 5B, repeat steps q to r.

•If the same frequency is programmed into a pair of scan edges, programmed scan will not function.

7

[EXAMPLE]: Programming 145.300 MHz into scan edges 1A.

Rotate for setting frequency, etc. Push Rotate

Push for 1 sec. and continue to push ➠

“Beep“

“Beep

“Beep

“

“Beep

42