Memory clearing

Contents of programmed memories can be cleared (blanked), if desired.

qPush [V/MHz•SCAN] to select VFO mode. w Push [S.MW•MW] momentarily.

!” indicator and the memory channel number blink.

eRotate [DIAL] to select the memory channel to be cleared.

• Memory channels not yet programmed are blank.

MEMORY OPERATION 5

rPush [S.MW•MW] momentarily, then push [S.MW•MW] again for 1 sec.

This operation must be performed within 1.5 sec.

• 3 beeps sound, then the frequency is cleared.

• “!” indicator and the channel number blink continuously.

• When clearing the call channel, the current VFO conditions are

5

re-programmed into the call channel automatically.

 

tPush [V/MHz•SCAN] to return to VFO mode.

NOTE: Be careful!— the contents of cleared memories CANNOT be recalled.

[EXAMPLE]: Clearing memory channel 20.

Push

to select VFO.

Push

.

Rotate

for selecting memory channel.

Push

momentarily, then push

again for 1 sec.

Push any switch, except

.

BeepBeep

Beep

34

Page 49
Image 49
Icom IC-208H instruction manual Memory clearing, Rotate Dial to select the memory channel to be cleared