Icom IC-208H Skip channel setting, Push Monidtmf to exit set mode, Select a memory channel

■Skip channel setting

[

The memory skip function speeds up scanning by checking only those memory channels not set as skip channels. Set skip channels as follows.

The display shows that mem- ory channel 1 is set as a skip channel.

qSelect a memory channel:

➥Push [M/CALL•PRIO] to select memory mode.

➥Rotate [DIAL] to select the desired channel to be a skip channel.

wPush [SET•LOCK] to enter set mode.

ePush [SET•LOCK] or [S.MW•MW] several times until

“CHS” appears as shown above.

rRotate [DIAL] to turn the skip function ON or OFF for the

selected channel.

• “~” appears : The channel is skipped during scan. (CHS-ON)

•“P ~” appears : The channel is skipped during scan and the programmed frequency is skipped during VFO scan, such as programmed scan.

(CHS-ON)

•“~” disappears : The channel is scanned during scan. (CHS-OF)

tPush [MONI•DTMF] to exit set mode.

SCAN OPERATION 7

zSelect a memory channel.

SET ➥ Select memory mode by pushing [MR/CALL].

B➥ Push [Y] or [Z] to select the desired channel to be a skip channel.

•Direct memory channel selection is also available. x Push [SET B(D-OFF)] to enter set mode.

cPush [SET B(D-OFF)] or [ENT C(T-OFF)] several

times until “CHS” appears as shown at left.
v Push [Y] or [Z] to set or cancel the skip setting.	7
• See item r at left for skip indicator details.

b Push [CLR A(MW)] to exit set mode.

44