Icom IC-208H instruction manual Using the tuning dial, Using the Y/Z keys, Using the keypad

■Using the tuning dial

qRotate [DIAL] to set the frequency.

•If VFO mode is not selected, push [V/MHz•SCAN] to select VFO mode.

•The frequency changes in the selected tuning steps. (p. 13)

[DIAL]

[V/MHz•SCAN]

wTo change the frequency in 1 MHz (10 MHz for some versions) steps, push [V/MHz•SCAN], then rotate [DIAL].

•Pushing [V/MHz•SCAN] for 1 sec. starts scan function. If scan starts, push [V/MHz•SCAN] again to cancel it.

While 1 MHz tuning step is	While 10 MHz tuning step
selected, the digit below	is selected, the digit below
100 kHz disappear.	1 MHz disappear.

■Using the [Y]/[Z] keys

➥Push [Y] or [Z] to select the desired frequency.

YZ • Pushing [Y]/[Z] for 1 sec. activates a scan. If scan starts, push [Y]/[Z] or [CLR A(MW)] to cancel it.

SETTING A FREQUENCY 2

■ Using the keypad

The frequency can be directly set via numeral keys on the mi- 2 crophone.

zPush [VFO/LOCK] to select VFO mode, if neces-

ENT sary.

Cx Push [ENT C(T-OFF)] to activate the keypad for

digit input.

cPush 6 keys to input a frequency.

•When a digit is mistakenly input, push [ENT C(T-OFF)] to clear the input, then repeat input from the 1st digit.

•Pushing [CLR A(MW)] clears input digits and retrieves the frequency.

[EXAMPLE]: Setting frequency to 145.3625 MHz.

Push

Push

Push

Push

12