SUPER MICRO Computer 6025B-3R user manual Control Panel, Front and Rear Chassis Views

SUPERSERVER 6025B-3/6025B-3R User's Manual

Figure 6-1. Front and Rear Chassis Views

3.5" Drive Bays USB/COM Ports Slim DVD-ROM Drive Control Panel

SAS Drives (8)

Keyboard/Mouse Ports		Parallel Port		7 Low-Profile PCI Slots
Power Supply*	USB Ports	COM1 Port	VGA Port	Ethernet Ports

*Note: the lower (bottom) power supply module is a dummy on the 6025B-3. On the 6025B-3R, a redun-

dant power supply module is located here.

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1 connector on the serverboard to provide you with system status indications. A ribbon cable has bundled these wires together to simplify the connection. Connect the cable from JF1 on the serverboard to JP4 on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both JF1 and JP4. Pull all excess cabling out of the airflow path. The LEDs inform you of system status. See Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1 can be found in Chapter 5.

6-2