SVAT Electronics CLEARVU10 EVENT/SENSOR Menu, Making Changes to the HDD Event Menu

SVAT ELECTRONICS

now you can see

NOTE: Each of the settings within the CONTROL DEVICE menu are described in detail below.

SYSTEM ID: Must be different from any other DVRs being accessed by the remote. You can choose between 1-254 for an ID.

PROTOCOL: Used to select the protocol (refer to the external remote’s user manual).

BAUD RATE: Allows you to set up the baud rate (refer to the external remote’s user manual).

EVENT/SENSOR MENU

The EVENT/SENSOR menu allows you to make changes to the following: HDD EVENT, ALARM IN, ALARM OUT, BUZZER OUT, and E-MAIL NOTIFICATION. The HDD EVENT menu allows you to set the DVR to check the Hard Drive for errors and alert you if any are detected. The ALARM IN menu allows you to configure any external sensors or alarms. ALARM OUT allows you to set the type of action which will be sent to the alarm outputs. Finally, the BUZZER menu allows you to set the DVR to emit an alarm beep when specific alarms are detected.

MAKING CHANGES TO THE HDD EVENT MENU

1.Click the EVENT/SENSOR button.

2.Click the HDD EVENT title on the left hand side of the window.

3.To navigate through the HDD EVENT menu, use the mouse to click the status (OFF, ON, etc) of the setting you wish to change. You will see the outline of the status turn green.

4.Use the buttons to choose the preferred setting.

5.When you have made all the desired changes to the HDD EVENT menu, click APPLY. If you wish to exit without saving changes, click in the top right corner of the window.

NOTE: Each of the settings within the HDD EVENT menu are described in detail below.

CLEARVU10 56