SVAT Electronics CLEARVU10 instruction manual Additional Group Settings, Additional Configuration

	SVAT ELECTRONICS
ADDITIONAL GROUP SETTINGS	now you can see

1.To complete the installation you must use the mouse to check or uncheck boxes and select the following custom settings

2.Event: Check the event occurrences that cause the DVR to send entries to the Event Viewer and remote client system log (it is recommended to check all four boxes). This way, if you leave your computer for a certain period of time, you can check the event viewer button to see if you missed anything while you were gone. For example, if a camera loses power you will see the message “6/23/2008 0:59:10: Recording of Camera #1 Stopped” in the Event Viewer window.

3.In/Out: Check the ‘Audio Out’ box to enable 2 Way Communication (by enabling this feature, you will be able to send audio to the DVR via your computer’s microphone).

4.Checking the ‘Alarm Out’ button means you will be able to enable the remote alarm trigger function.

5.‘Monitoring Audio’ allows you to listen in on any audio equipped cameras (if connected). Use the dropdown box to choose which camera you would like to listen in on.

6.Under ‘Connection Retries’, choose the number of times the remote client will attempt to connect to the DVR before giving an error.

7.Click ADD to save the DVR’s settings.

8.Click OK if you are finished. If you would like to configure additional settings, do not click OK, and follow the instructions below.

TIP: Each DVR group can contain up to 4 DVRs. Simply repeat all steps from “Creating a Connection Group” through “Additional Settings & Configuration” for each DVR. Additionally, please note that only one group can be connected at a time.

For example, you would need to disconnect from the’‘OFFICE’ group before connecting to the ‘PARKING LOT’ group.

ADDITIONAL CONFIGURATION

1.In the local setup window, click the “Configuration” tab.

2.Use the mouse to check or uncheck boxes and select the following custom settings:

CLEARVU10 81