TANDBERG D13898.04 manual Preparing for Use, What’s in the Box?, Rack Mounting optional

Installing the Content Server

Preparing for Use

What’s in the Box?

To avoid damage to the unit during transportation, the Content Server is delivered in a special shipping box, which should contain the following components:

•CD with User Guide and other documentation

•Rack-ears, screws and screwdriver

•Cables

•Power cable

•Ethernet cable

•TANDBERG Content Server.

Kindly report any discrepancies to your TANDBERG Representative immediately.

		TANDBERG CONTENT SERVER
		USER GUIDE
	Rack Mounting (optional)
 Before starting the rack mounting please	 Disconnect the AC power cable, if	 Make sure that the mounting space is
make sure the TANDBERG Content	applicable.	prepared according to the Installation
Server is placed securely on a hard flat		Site Preparations below left.
surface.
		10 cm
		10 cm

Installation Site Preparations

•Make sure that the Content Server is accessible and that all cables can be easily connected

•For ventilation: Leave a space of at least 10cm (4 inches) behind the Content Server’s rear panel and 10cm (4 inches) in front of the front panel

•The room in which you install the Content Server should have an ambient temperature between 0ºC and 35ºC (32ºF and 95ºF) and between 10% and 90% non- condensing relative humidity

•Do not place heavy objects directly on top of the Content Server

•Do not place hot objects directly on top, or directly beneath the Content Server

•Use a grounded AC power outlet for the Content Server.

Table of	What’s New in	Trademark/
Contents	this Version?	Licenses

Attach the brackets to the Content Server on both sides of the unit.

Connect a LAN cable from the LAN 1 connector

on the Content Server to your network.

The LAN 2, 3 and 4 connectors are

not used and should be left open.

Safety/ Introduction Installation Environmental

Insert the Content Server into a 19” rack, and secure with screws in the front (four screws).

Connecting Cables

Connect the AC power

cable to an electrical distribution socket. Press the power switch button at the back side to 1 to turn on the Content Server.

On the front panel of the system the power indicator LED, marked Pwr, will light up.

Quick Setup	Operation	Administrator	Conference	View	Appendices
		Settings	Setup	Conferences

D 13898.04 DECEMBER 2006

16