TANDBERG TC3.0 The Standby settings The Standby settings,

D14635.02—MARCH 2010 28
TANDBERG Codec C90 and Profiles using C90 Administrator guide
Contents Introduction Advanced configuratio n Password protection About monitors Audio matters Appendices Contact us
www.tandberg.com
Standby BootAction
Decide what the system is goi ng to do on boot.
Valuespace: <None /Preset1/Preset2/P reset3/Preset4/Pre set5/Preset6/Pre set7/Preset8/
Preset9/Preset10/Pr eset11/Preset12/Preset13/Preset14/Preset15/Restor eCameraPosition/
DefaultCameraPositi on>
None: No action.
Preset 1..15: Activate the selected preset.
RestoreCameraPosit ion: Set the camera to the posi tion it had before the last boot.
DefaultCameraPosi tion: Set the camera to the fac tory default position.
Example: Standby BootAc tion: DefaultCameraPosition
Standby Control
Determine whether the sys tem should go into standby mode o r not.
Valuespace: <On/ Off>
On: Enter standby mode whe n the Standby Delay has timed o ut. Requires the Standby De lay to be set
to an appropriate value.
Off: Not entering stan dby mode.
Example: Standby Control: On
Standby Delay
Define how long (in minute s) the system shall be in idle m ode before it goes into standby m ode. Requires
the Standby Control to be enab led.
Valuespace: <1..480>
Range: 1-480 minutes
Example: Standby Delay: 10
Standby StandbyAction
NEW TC2.1 Decide what the system is going to do whe n going into standby mode.
Valuespace: <None /PrivacyPosition>
None: No action.
PrivacyPosition: Turns the came ra to a sideways position for priv acy.
Example: Standby Stand byAction: PrivacyPosition
Standby WakeupAction
Decide what the system is goi ng to do when leaving standby m ode.
Valuespace: <None /Preset1/Preset2/P reset3/Preset4/Pre set5/Preset6/Pre set7/Preset8/
Preset9/Preset10/Pr eset11/Preset12/Preset13/Preset14/Preset15/Restor eCameraPosition/
DefaultCameraPositi on>
None: No action.
Preset 1..15: Activate the selected preset.
RestoreCameraPosit ion: Set the camera to the posi tion it had before entering sta ndby.
DefaultCameraPosi tion: Set the camera to the fac tory default position.
Example: Standby WakeupAc tion: RestoreCameraPosition
The Standby settings The Standby settings, cont...
Contact us
Contents
Introduction
Advanced configuratio n
Password protection
About monitors
Audio matters
Appendices
Advanced config.