TANDBERG TC3.0 manual Network 1. IPv4 QoS Diffserv Signalling, Network 1. TrafficControl Mode

TANDBERG Codec C90 and Profiles using C90 Administrator guide

ContentsContents

IntroductionIntroduction

AdvancedAdvancedAdvancedconfigurationconfigurationconfig.

PassPasswordord protectionprotection

AboutAboutmonitorsonitors

AudioAudiomattersat ers

AppendicesAppendices

ContactContactusus

The Network settings, cont...

Network [1..1] IPv4 QoS Diffserv Signalling

The DiffServ Signalling setting is used to define which priority Signalling packets should have in an IP network. Enter a priority, which ranges from 0 to 63 for the packets. The higher the number, the higher the priority. These priorities might be overridden when packets are leaving the network controlled by the local network administrator.

Valuespace: <0..63>

Signalling: A recommended value is DiffServ Code Point (DSCP) AF31 which equals the value 26. If in doubt, contact your network administrator.

Example: Network 1 IPv4 QoS Diffserv Signalling: 0

The Network settings, cont...

Network [1..1] TrafficControl Mode

Configure how video packets transmission speed shall be controlled.

Valuespace: <On/Off>

On: Transmit video packets at maximum 20Mbps. Can be used to smooth out bursts in the outgoing network traffic.

Off: Transmit video packets at link speed.

Example: Network 1 TrafficControl: On

Network [1..1] IPv4 QoS Diffserv Video

The DiffServ Video setting is used to define which priority Video packets should have in an IP network. Enter a priority, which ranges from 0 to 63 for the packets. The higher the number, the higher the priority. These priorities might be overridden when packets are leaving the network controlled by the local network administrator.

Valuespace: <0..63>

Video: A recommended value is DiffServ Code Point (DSCP) AF41, which equals the value 34. If in doubt, contact your network administrator.

Example: Network 1 IPv4 QoS Diffserv Video: 0

Network [1..1] MTU

Set the ethernet MTU (Maximum Transmission Unit).

Valuespace: <400..1500>

Range: Select a value from 400 to 1500.

Example: Network 1 MTU: 1500

Network [1..1] Speed

Set the ethernet link speed.

Valuespace: <Auto/10half/10full/100half/100full/1000full> Auto: Autonegotiate link speed.

10half: Force link to 10Mbps half-duplex.

10full: Force link to 10Mbps full-duplex.

100half: Force link to 100Mbps half-duplex.

100full: Force link to 100Mbps full-duplex.

1000full: Force link to 1Gbps full-duplex.

Example: Network 1 Speed: Auto

D14635.02—MARCH 2010 23 www.tandberg.com