Continuous Playback

2

 

 

1

 

4

 

4

 

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3

Continuous playback can be performed between TAPE I and TAPE II. When one tape is played back to the end, the other tape automatically starts playback, in a relay fashion.

1Load pre-recorded tapes into the TAPE I and TAPE II compartments.

2Set the Dolby NR switch.

Always set the Dolby NR switch to the same position that was used for recording.

3Set the REV MODE switch to the p (CONT PLAY) position.

4Press the play button (h or y) of the deck you want to start first.

You can start continuous playback from either TAPE I or

TAPE II.

Playback cycles through four tape sides as follows:

TAPE I

Side “A”

w Side “B”

 

2

x

TAPE II

Side “B”

s Side “A”

Playback will automatically stop when both sides of both tapes have been played back 5 times continuously.

Blank Scan

The Blank Scan function detects 10 seconds or more of blank and skips over it.

To activate this function, press the BLANK SCAN button followed by the desired play button (h or y).

activated.

ENGLISH

< The BLANK SCAN indicator lights when this function is

 

< To disable this function, press the BLANK SCAN button again. The indicator turns off.

< Very quiet passages in music are likely to be identified as blanks. If you are worried about this, switch off Blank Scan.

13