Mic Mixing Recording

This function allows you to record your voice and another audio source together on a cassette tape.

<The mic sound is fed into both the Left and Right channels so it is located in the center of the stereo image.

<You have the choice of either selecting the audio source you want on the amplifier connected to the LINE IN jacks of the deck, or plugging the desired source directly into the deck’s LINE IN jacks.

<To prevent feedback (howling), disable the speaker outputs from the amplifier. Use headphones to monitor recording.

<This cassette deck is not compatible with stereo mics. Always use a mono mic.

Adjusting Mix Recording Level

To record a mix of voice and another audio source, you need to adjust the mic input level and then fine tune the overall recording level.

1.Plug your microphone into the MIC jack on the front panel.

2.Start playing the audio source, switch the deck into the record-pause mode (by pressing the RECORD button), and temporarily adjust the REC LEVEL control to a relatively low level.

3.Speak into the mic and adjust the MIC level control to get the optimum balance between your voice and the other source.

4.Fine tune the overall recording level using the REC LEVEL control so that the level meter reads 0 dB at peaks.

5.When everything is ready, start recording as instructed earlier in this manual.

Audio source

Adjustment of mic input level

Adjustment of overall recording level

18