In this manual we only refer to the buttons on the cassette deck itself. However, their remote counterparts can be used in the same way.

APower switch

This switch toggles the unit on/off.

The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position.

BReverse mode switch (REV MODE)

This switch is used to switch between reverse modes.

CTIMER switch

This switch is provided for use with a commercially available audio timer, to allow timer controlled recording or playback. Normally, leave this switch to the OFF position.

DDOLBY NR switch

This switch toggles the Dolby Noise Reduction system on/off. In playback you need to set this switch to the same position as when the recording was made.

ETAPE I compartment

FRemote sensor

This receives remote commands. When using the remote control unit, point it at this sensor.

GCounter clear buttons (CLEAR I and CLEAR II)

Pressing these buttons reset the tape counter readings for TAPE I and TAPE II, respectively.

HINTRO CHECK button

Pressing this button allows you to identify recorded segments by listening to the first 15 seconds of each segment.

ISynchro reverse button (SYNC REV)

Pressing this button activates the synchro reverse dubbing function.

JBLANK SCAN button

This button toggles Blank Scan on/off.

KDisplay

This shows tape counters, level meters, etc.

LParallel record button (PARALLEL REC)

This button lets you simultaneously record on both decks.

MDubbing start button (DUB START)

This button is used when copying the contents of a tape from TAPE I to TAPE II, either at normal or high speed.

On the remote control unit a pair of buttons is provided for each speed. You need to press both buttons at the same time.

NTAPE II compartment

OEJECT buttons

Pressing these buttons opens the TAPE I and TAPE II compartments.

PTape transport control buttons

RECORD

Pressing this button shifts the corresponding deck to record- pause mode.

When you use the remote control unit, you need to press a pair of buttons at the same time to shift either deck to record- pause mode.

PAUSE

Pressing this button temporarily stops playback or recording.

Recording mute (REC MUTE)

This button is for creating the 4-second blank space needed for proper operation of the Computomatic Program Search (CPS) function.

m/,

Fast-forward/Rewind

H

Stop of playback/record

h / y

Reverse side play/Forward side play

QHeadphones jack (PHONES)

Plug your headphones into this jack.

RPITCH CONTROL

This control is used to vary the playback speed.

SREC LEVEL control

This control is used to adjust the recording level.

TMIC jack and level control

Insert your microphone into this jack and use the knob to adjust the level of mic input.

<The MIC jack is mono. You cannot use a stereo microphone with this cassette deck.

ENGLISH

9