<During dubbing, either the NORM DUB or HIGH DUB indicator lights steadily on the display.

<During normal speed dubbing, only the following buttons work:

TAPE I deck: STOP (H)

TAPE II deck: PAUSE, REC MUTE, STOP (H)

During high-speed dubbing, only the stop button (H) works.

<Pressing the stop button (H) on either deck stops both tapes at once.

<Neither DUB START button works immediately after the tape is fast-forwarded or rewound to the end. Wait for 5 seconds or more before pressing the button.

<During dubbing, the pitch control does not work.

<Recording level adjustment is not necessary for dubbing, as the recording level is set to the level of the pre-recorded tape. Operating the REC LEVEL control, before or after starting dubbing, has no effect at all.

<If a nearby television set is switched on during high-speed dubbing, a high-pitched interference noise may be recorded on the tape. To avoid this, either perform dubbing at normal speed, or turn off the television.

Editing during Dubbing (only at normal speed)

You can prevent unwanted songs or unnecessarily long blanks from being dubbed, or you can create blanks between songs.

1. At the desired point during dubbing, press the PAUSE

 

 

button on the TAPE II deck. The TAPE II deck only enters

ENGLISH

the pause mode, allowing you to let unwanted songs

 

go by.

 

To create a 4-second blank between songs, press the

 

REC MUTE button on the TAPE II deck. The TAPE II deck

 

 

temporarily stops after recording no signal for 4

 

seconds.

 

<The TAPE I deck continues playback when the TAPE II deck is in pause mode.

2.To resume dubbing, press the PAUSE button on the TAPE II deck.

21