Loading the Device Table and Configuration Parameters From a File
2.10Loading the Device Table and Configuration Parameters From a File Ð the Load Command
When you select the L command, a submenu displays options for choosing a file to load. The commands in this submenu are listed below; the letter that invokes the command is printed in bold type.
Command | Function |
|
|
Device Table | Load a device table file. |
|
|
Configuration | Load configuration parameters from a configuration/batch file. |
Both load options prompt for only one parameterÐthe file to be loaded. If the file specified does not exist, an error message is displayed as follows:
Can not open file: <file name> (hit any key)
Press any key to erase the error message and return to the prompt to enter the correct file name.
If a file that is not a valid device table is specified, the following error message is displayed:
Invalid/Wrong device table file: <file name> (hit any key)
Press any key to erase the error message and return to the configuration com- mand menu.
Loading the Device Table
Select this option to load the current device table from a file that you specify. The device table window is updated as the current device table is reloaded.
Load the Configuration Parameters
This option loads the configuration parameters, listed below, from the specified configuration file.
Communication port
Current device
Device table
If the device table file is specified, it will be loaded as the current device table, and the device type specified in the configuration/batch file will be searched for in the table.
Operating in the Configuration Window |
