Properly Installing the Programmer Hardware

To install a DIP device:

1)Align the IC so that pin 1 is oriented in the upper-left corner, indicated on the printed circuit board by a circled number 1:

2)Raise the locking arm, pulling it toward you to the upright position.

3)Insert the IC.

DIP

locking arm

4)Lower the locking arm by pushing it away from you and down, as far as it will go.

locking arm

DIP

Note:

If you install a 2732 device in U2, be sure to use the bottom socket holes, leaving the top four socket holes unused. The correct position for a 2732 is indicated by a bracket on the printed circuit board to the left of the socket.

1-12

Introduction and Installation

Page 26
Image 26
Texas Instruments TMS370 manual To install a DIP device